|
Install to an
existing air supply. A standard quick disconnect is
provided for your convenience.
To fill the PowderPerfekt®
unit unscrew the canister, remove the diffuser and fill with your favorite
powder to a level just below the diffuser . Then
replace the diffuser. A LITTLE POWDER GOES A LONG WAY.
The filtered
dry air syringe nozzle is fitted into the PowderPerfekt®
Instrument and secured with the black thumbscrew.
Powder flow is instantly controlled by thumb
pressure on the filtered dry air syringe button. If
your airline pressure is greater than 60psi, make sure the diffuser
is in place. With the
diffuser in place the powder flow
will be restricted, thus eliminating any problems with the flow of powder.
The outlet nozzle can be
rotated to accommodate any area of the mouth. It can
also be removed with a twisting pull, for cleaning and sterilization.
This device works perfectly, only when kept clean.
The PowderPerfekt® can
be cleaned, by removing the canister and blowing air through the beveled
exit tube opening. With canister and nozzle removed,
clear all powder build up from passages with the brush
and probe provided. Make this a regular service,
because cleanliness means constant success. Tapping the powder container
occasionally helps to settle the powder below the diffuser.
This makes for greater efficiency. The additional
nozzle provided enables you to have constant use of your PowderPerfekt
unit.
The dry air syringe is perfectly suited for
the following procedure. With use of the rubber hose
adapter and the access®
tip, this syringe has unlimited uses in any procedure that requires dry
clean filtered air! It is excellent for cleaning
powder out of the interproximal surfaces and the sulcus.
Changing from the dry air syringe to powdering only takes a couple
of seconds. Periodically, change the cotton roll in
syringe handle. Disconnect from air source first.
The unit should be stored upright.
The air syringe will fit into any standard air hand piece holder
available from your dental supplier.
If for some reason the unit is contaminated
by water, the whole unit can be thoroughly rinsed and washed.
It should be thoroughly dried before it is filled with powder and
reused. |